Seats and Belts

     Before the seats were installed, I needed to install the seatbelts.  I opted for the four point harness on the Caterham.  The lower two mounting points were simple to screw in, but the top mounting points would not catch the bolt.  I ended up re-tapping the holes.  Because the roll bar is in the way, it makes retapping the outside holes very difficult.  I would recommend retapping before installing the roll bar. 

    After getting the seatbelts secured, I dropped in the seats and bolted them to the floor.  I tried to bolt the rear holes first, but that made it hard to align the front holes because the sliding seat mount covered them.  Installing the front bolts first is the only way to get the seats in.