Fluid Install

 Before starting the car for the first time, I needed to fill fluids and install the exhaust piece that fit onto the collector.  Installing the exhaust was pretty easy, but I had to slightly bend the mounting bracket to make the exhaust fit.  

Getting the brakes setup was an easy process:

1- Fill brake master cylinder

2- Crack nipple off left rear brake

3- Pump brake pedal

4 - Hold brake pedal down

5 - Tighten nipple

6 - Pump brake pedal 3 times

7 - Hold brake pedal down 

8 - Crack then retighten nipple

Repeat steps 2 - 8 until no bubbles come out.

The order for brakes is - 

1 - Left rear

2 - Right rear

3 - Right front

4 - Left front

To fill the clutch. I attached a hose to the nipple on the bell housing.  I then repeated the same brake filling process with the clutch.

To fill the radiator, I first filled the coolant expansion tank and then filled the radiator directly.  Once the car starts, I will add extra fluid as it starts circulating.  

The engine came prefilled with oil, so I just checked the levels.