To connect the Dedion Tube to the chassis, I needed to install the rear dampers. For this step, the upper bolt is in the way of the roll bar mounting bolt. So I skipped ahead and installed the roll bar so I did not need to uninstall the dampers later.
I applied plenty of copper grease and installed the dampers. I torqued down everything to spec.
The next step was to attach the radius arms. Again this was a simple installation of two bolts, to which I applied copper grease then torqued down to spec.
I applied plenty of copper grease and installed the dampers. I torqued down everything to spec.
The next step was to attach the radius arms. Again this was a simple installation of two bolts, to which I applied copper grease then torqued down to spec.
Comments
Post a Comment